PLB20140 Carbon fibre reinforced drive belt set for Brose S&T engine

Description

PLB20140 Brose S&T aluminium coppa. Both sides of the engine's Brose carbon fibre belt must be liberally lubricated with ”technical” petroleum jelly. Failure to do so will result in high belt wear and temperature and may cause excessive noise. Technical Vaseline is a non-corrosive mixture of oils and long-chain non-polar hydrocarbons, but is generally thicker than pharmaceutical grade Vaseline. The product has a low melting point which is important if the belt dries out and starts to heat up.

PLB20151 Technical Vaseline for lubricating the drive belt is best applied with an old toothbrush that is good for it.

NOTE ! a few tips. Remember to remove the pulley adjusting screw before removing the side cover. Use a 6mm thread pin to clean the thread. Install the spindle only after you have installed the side head to make the job easier Lubricate the belt on both sides Remember the belt tension is only 0,2nm if it gets too tight it can break the pulley and the electric motor bearing as well as the belt. Torque wrench 0,2nm product number PLA00925 can be found in the Brose tools section..